Beckhoff BC7300 Bedienungsanleitung PDF herunterladen (Seite 44)

Appendix

44 BC7300

Blink block (PRG-CRC)

Creating the BOOT Program

The next step is the creation of a boot project. To achieve this, select,

when you are logged in, Online/Create boot project. The PLC LED flashes

while the boot project is being created. Now set the MODBUS slave

address and switch the Bus Terminal Controller off and then on again.

Remove the programming cable, and connect the MODBUS cable.

MODBUS Communication

Function 4 is used in order to obtain the states of the counters in the two

16-bit output words in the MODBUS master.

1 2 ... 39 40 41 42 43 44 45 46 47 48

Keine Kommentare

Beckhoff BC7300 Bedienungsanleitung Seite 44