Beckhoff Z1003 Bedienungsanleitung PDF herunterladen

Assembly instructions for the connector Z1003

Assembled view

Prepare cable ends

First strip off the outer cable sheath (1) of the optical waveguide Z1101 by approx. 100 mm and cut the strain relief

(yellow) back to the start of the outer cable sheath,

by using a sharp edge cutter.

Cut the black fibre cover (2) by approx. 10 mm.

The plastic fibre (3) must not be hurt! Damaged fibres cause increased cable attenuation.

Assemble connectors

Put the cap nut (4) onto the cable.

Put the connector (5) as far as it will go onto the fibre. The fibre must protrude from the connector guide by approx. 2 mm,

so that any cracks present in the fibre end face are located outside the connector and can be removed by abrasion.

Tighten the cap by hand (don't use a tool).

Pay attention during the stripping and installation, that

the light guide must not be kinked

the bending radius of the cable must not be tighter than 30mm.

Optical waveguide

Version 1.0

Page 1

1 2

Assembly instructions for the connector Z1003 Assembled view Prepare cable ends lFirst strip off the outer cable sheath (1) of the optical waveguide

Seite 2

Do not cut off the protruding fibre end, because this could lead to crack formation, but labrade the protruding fibre end flush with the connector g

Weitere Dokumente für Ausrüstung Beckhoff Z1003

Keine Kommentare