Beckhoff AX2000 PROFIBUS DP communication profile Bedienungsanleitung PDF herunterladen (Seite 13)

2.2.3 Setup Software

2.2.3.1 Screen page PROFIBUS

This screen will only appear, if the PROFIBUS hardware is built into the servo amplifier. The screen

page displays the PROFIBUS-specific parameters, the bus status, and the data words in the trans

mit and receive directions, as seen by the bus-master. This page is helpful when searching for

errors and commissioning the bus communication.

Baudrate: The baud rate set by the PROFIBUS master.

PNO Identno.: The PNO identification is the number for AX2000/2500 from the list

of ID-numbers set by the PROFIBUS user organization.

Address: Station address of the amplifier (setting see p.8).

PPO type: AX2000/2500 only supports PPO-type 2 of the PROFIDRIVE profile.

PROFIBUS Interface states:

Shows the present status of the bus communication. Data can only be

transferred across the PROFIBUS when the “Communication OK”

message is black (not shown in gray).

Input: The last PROFIBUS object received by the master.

Output: The last PROFIBUS object sent by the master.

The data for input/output are only transferred, if the threshold monitoring for the

AX2000/2500 has been activated in the master’s hardware configuration.

PROFIBUS for AX2000/2500 13

BECKHOFF 12/05 Installation / Setup

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 50 51

Keine Kommentare

Beckhoff AX2000 PROFIBUS DP communication profile Bedienungsanleitung Seite 13