Beckhoff CB4051 Bedienungsanleitung PDF herunterladen (Seite 24)

Chapter: Connectors LCD

page 24 Beckhoff New Automation Technology CB4051

4.7 LCD

The LCD is connected via two 15 pin connectors (Hirose DF13-15P-1.25DSA, mating connector:

DF13-15S-xxx). The power supply for the display is also provided through these connectors. The CB4051

board only supports displays with LVDS interface. For displays with digital interface an extra receiver

board is available. There is no support for DSTN displays.

With the LVDS interface it is possible to trigger LVDS displays with a maximum of 18 Bit colour depth

and one or two pixels per clock. For single pixel displays only one connector is necessary. However, if

you want to read the display's EDID data the second connector must be connected.

The display type can be chosen over the BIOS setup. Please contact your sales representative regarding

an appropriate cable to connect your display.

The following table shows the pin description for the first bit ("even" pixel).

Name Description

1 GND ground

2 GND ground

3 TXO00# LVDS even data 0 -

4 TXO00 LVDS even data 0 +

5 TXO01# LVDS even data 1 -

6 TXO01 LVDS even data 1 +

7 TXO02# LVDS even data 2 -

8 TXO02 LVDS even data 2 +

9 TXO0C# LVDS even clock -

10 TXO0C LVDS even clock +

11 TXO03# LVDS even data 3 -

12 TXO03 LVDS even data 3 +

13 BL_VCC switched 5 volt for backlight

14 FP_3.3V switched 3.3 volt for display

15 FP_3.3V switched 3.3 volt for display

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 69 70

Keine Kommentare

Beckhoff CB4051 Bedienungsanleitung Seite 24